Запустите команду PLINE, вызвав ее из меню или панели инструментов. Ответьте на запросы:
Command: _pline
Specify start point: 230,60
Current line-width is 0.0000
Specify next point or [Arc/Halfwidth/Length/Undo/Width]: w
Specify starting width <0.0000>: 2
Specify ending width <2.0000>: 2
Specify next point or [Arc/Halfwidth/Length/Undo/Width]: 260,60
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: Arc
Specify endpoint of arc or
[Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: Dir
Specify the tangent direction for the start point of arc: 270
Specify endpoint of the arc: 360,60
Specify endpoint of arc or
[Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: line
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 390,60
Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]:
Enter
В итоге должна получиться фигура, проставленная на рисунке
Проанализируйте каждый этап построения полилинии
